A crown, an inlay, and an onlay

When we refer to crowns, onlays and inlays, we are referring to whether we need to restore the cusp of the tooth, and if so, all of the cusps or some of the cusps. The cusp is the pointed or rounded projection on the chewing surface of the tooth. Molars typically have four cusps as shown by the four purple asterisks in the top image and bicuspids, also called pre-molars, typically have two cusps as shown by the two blue asterisks in the top image.

When a tooth has been severely weakened or fractured, we will usually place a crown, which covers all of the cusps. In the image on the right, the left tooth is prepared as shown in the middle image and the crown was made in the lab and the final result is in the bottom image.

When a tooth has one or more cusps that are weakened or fractured but other cusps that are still strong, we can elect to do an onlay.  An onlay can cover one or more cusps while retaining some of the tooth above the gumline. In the example on the right, the lower left cusp for the middle tooth was determined to be too weak so it was capped but the remaining three cusps were healthy so they were left untouched. The porcelain restoration was made in the lab and the final result is in the bottom image.

When the cusps of the tooth are all healthy and structurally sound, we can elect to restore the surrounding structure but leave the cusps intact. This is called an inlay as shown by the tooth on the far right. The amalgam restoration needed to be replaced and it was restored with a porcelain inlay that was made in the lab and the final result is in the bottom image.

Please see the Crowns Gallery and the Fillings Gallery to view the type of results we can achieve with crowns, inlays, and onlays.